Big5 2009, UAE, Dubai

We will be glad to see you at our stand X71 at Zabeel Hall on Big5 2009, 23 – 27 of November. The following formwork systems will be shown: frame, large-area, circular column, flooring.

1. Building of the corners is based on strong and stable inner corner part.
   There are two ways to build external right angle:
- using universal element;
- using external corner part.
Using universal element, wall thickness can be set with step of 5 cm.





2. Formation of external right corner using universal element.




Necessary number of universal connectors to be set on universal element is as follows:
Universal element 0,90 х 1,35 m — 2 pc.
Universal element 0,90 х 2,85 m — 4 pc.
Universal element 0,90 х 3,30 m — 5 pc.
Universal element 1,35 х 1,35 m — 2 pc.
Universal element 1,35 х 2,85 m — 4 pc.
Universal element 1,35 х 3,30 m — 5 pc.
Holes on the flank side of inner corner part are made for building up the casing elements with help of universal connector and back nut.
3. Steel jacks are set on the corner parts and are of high durability and long-term service. Jack is fastened to the end side of the frame element using two corner connectors and star nuts. While using steel jacks clamping bars are not required. Using steel jack of 5 cm thick, it is possible to make wall thickness equal to, i.e. 25 cm and 35 cm.

4. Building of external right corner using external corner.
It is possible to effectively raise strength in two-sided compensation in inner corner part by means of corner clamping bar.

Using external corner it is easy to build the corner in small space or at thick walls.
Necessary quantity of clamping devices with conditions of pressure of fresh concrete up to 60 kN/m2 and wall thickness of up to 60 cm is as follows: External corner 1,35 m long — 4 pc.
External corner 3,30 m long — 10 pc.



Attention! In conditions of fresh concrete pressure more than 60kN/m2 and wall thickness more than 40 cm it is essential to use cone bolts and clamping wedges instead of clamping devices.


5. Example of T-type connection.

6. Formation of edges using flank three-edged lath. Flank three-edged lath can be applied to the flank side of the element without nails. It is usually used for forming external corners together with universal element. Forming of edges is also possible with threeedged lath.



7. Formation of edges using three-edged lath and external corner. It is necessary to use three-edged lath while mounting external corners using external corner part and connections with clamping devices.